HydraPak | Performance Hydration Reservoirs, Soft Flasks ...

How to Use HydraPak Gear Cleaning Tablets

How to Use HydraPak Gear Cleaning Tablets

By HydraPak | Performance Hydration Reservoirs, Soft Flasks ... | Published: 2026-10-27

Category: Tips & Care

Learn how to use HydraPak Gear Cleaning Tablets to remove stains and odors from reservoirs and bottles. A simple step-by-step guide for a fresh hydration system.

Quick answer

Drop one Gear Cleaning Tablet into your HydraPak reservoir or bottle filled with three liters of warm water, let the effervescent bubbles work for 15-30 minutes, then rinse thoroughly.

Why use cleaning tablets instead of soap?

Soap can leave a residue that affects the taste of your water and can degrade the materials in your hydration system over time. Gear Cleaning Tablets use an effervescent action that lifts dirt and solids without leaving any soapy film behind. They are also effective at reaching tight corners and narrow tubes where a brush might not reach.

Step-by-step instructions

  1. 1. Fill your reservoir or bottle: Fill your HydraPak reservoir or bottle with three liters of warm water. Avoid using hot water, as it can damage the plastic or affect the tablet's performance. Check the capacity of your reservoir or bottle before adding water—if it's smaller than three liters, adjust the water volume accordingly and use a partial tablet.
  2. 2. Drop in the tablet: Drop one Gear Cleaning Tablet into the water. Do not crush or break the tablet; it will dissolve naturally as it fizzes. Make sure the tablet is fully submerged to ensure even distribution of the cleaning solution.
  3. 3. Let it soak: Allow the tablet to work for 15-30 minutes. For stubborn stains or odors, you can let it soak for up to two hours. Do not leave it overnight, as prolonged soaking may affect the material. Set a timer so you don't forget—over-soaking is a common mistake that can lead to unnecessary wear.
  4. 4. Rinse thoroughly: Empty the solution and rinse the reservoir or bottle several times with clean, fresh water. Make sure no residue remains, especially in the tube and bite valve. If you notice any lingering smell or taste, repeat the rinse cycle or do a second cleaning with a fresh tablet.
  5. 5. Air dry completely: Turn the reservoir or bottle upside down and let it air dry completely before storing. This prevents mold and mildew from forming. Do not reassemble or seal the reservoir while it is still damp—moisture trapped inside can lead to bacterial growth.

Product facts

  • Gear Cleaning Tablets (6 Tablets): Bottle Bright’s Gear Cleaning Tablets use effervescent bubbles to lift dirt and solids from the bottom and sides of containers, attacking tough stains and smells. Use one tablet per three liters of water. This means you don't need to scrub or use harsh chemicals—just drop a tablet in and let it do the work, which is especially helpful for cleaning reservoirs with narrow openings.
    Gear Cleaning Tablets (6 Tablets)
    Gear Cleaning Tablets (6 Tablets)

Shop Related Products

Gear Cleaning Tablets (6 Tablets)

Gear Cleaning Tablets (6 Tablets)

$8.04 $12.00

Shop Now